WD-40 brake cleaner 500 ml powerful degreaser designed for VESPA motorcycle braking systems

WD-40 brake cleaner 500 ml powerful degreaser designed for VESPA motorcycle braking systems The motorcycle is exposed to different climatic conditions and the elements that compose it attract dust, oil and other dirt, which can compromise its perfect functioning. This is particularly true for the braking system: here's how to clean the brake discs of your motorbike, one of the maintenance operations that must not be neglected! Correct maintenance and checking the good condition of the brake discs avoids accidents and allows you to travel safely. It is essential to choose the right products and our advice is to use the WD-40 Specialist Moto brake cleaner, developed specifically for motorcycle maintenance. WD-40 Specialist Moto Brake Cleaner is a very powerful degreaser, designed specifically for braking systems. The product is extremely volatile, which means it dries quickly. It is composed of solvents capable of quickly dissolving grease, dust, oil and other dirt on the brakes. With its high pressure jet and 360° valve, it manages to reach even the most hidden areas. This product effectively removes all residues. In addition to its use on brake discs and calipers, it also effectively degreases the clutch system and engine crankcase. This product is a must for motorcycle maintenance after the summer! In fact, it is ideal for removing salt residues on the braking system. Recommendations for use: never use the product on hot surfaces, decorative elements, plastic or rubber. Materials needed to carry out brake maintenance Before starting, make sure you have the necessary equipment available. You will need: Motorcycle stand Oscillation meter Screwdrivers and pliers Brush Brush Soft cloth Anti-drip tray Brake cleaner WD-40 Motorcycle Specialist How to maintain your motorbike's brakes First of all, place the motorbike on the stand, preferably centrally, to be able to work insecurity. Place the drip tray under the discs. For better cleaning, remove the wheel and then the caliper with its support without disconnecting the brake fluid lines. At this point check whether the discs are clean or need to be replaced. Shake the can of WD-40 Specialist Moto Brake Cleaner well. Then, generously spray WD-40 Specialist Moto Brake Cleaner onto the rotors and calipers and let the fluid drain into the container. Thanks to its very active formulation, this product quickly dissolves dust and dirt residues and dries in a few seconds. Scrub the items with a brush: for hard-to-reach corners, use a toothbrush which will clean the area more easily. Finally, remove any excess product with a soft cloth. After having completely eliminated the grease and rust, check that there is no longer any oil and grease on the disc, which would hinder the correct functioning of the pads. Once cleaning is complete you can reassemble the wheel, following the same steps as for disassembly. At this stage we recommend using a comparator to measure the oscillation of the disc, which must not exceed 0.10 mm. Excessive oscillation causes abrasion on the disc. Finally, once the discs have been reassembled, carry out a roadside check to verify the correct functioning of your motorbike. If there are oil leaks, carefully check the tightening of the bolts and the wheel housing. In case of difficulty, contact your trusted mechanic for further checks!